Keri-systems SM-2000 Manuel d'utilisateur télécharger pdf

IntelliProx – SM-2000

2305 Bering Drive 01830-003 Rev. H

San Jose, CA 95131 USA

(800) 260-5265 (408) 435-8400 FAX (408) 577-1792

Web: www.kerisys.com E-mail: [email protected] Page 1 of 10

IntelliProxQuick Start Guide

Contents

1. Features of the IntelliProx

System

2. Specifications

3. Cautions

4. Jumper Settings

5. IntelliProx Connections in Stand-alone Mode

6. IntelliProx Connections in 26-Bit Wiegand Reader Mode

7. Lock Connection Options

8. IntelliProx to D-Lite

Connections

9. First Time Power On Procedure: Pin and Memory Reset, LED Mode

10. Standard Operation

11. Troubleshooting the IntelliProx

12. Ordering Information

13. CE Declaration of Conformity

1.0 Features of the IntelliProx System

The IntelliProx is capable of operating as a stand-alone single-door entry control system or as a Wiegand output reader

with optional, back-up local door control. Small and unobtrusive, the IntelliProx can be mounted almost anywhere

within 500 feet of the reader (depending upon the type of reader and the maximum cable run allowed by that reader).

When used with a host controller, the IntelliProx can be mounted up to 500 feet from the host. Therefore, with the

appropriate reader, the reader to host distance can be as great as 1,000 feet.

1.1 Stand-alone Entry Control System

The IntelliProx has a capacity of 500 user cards, maintained in nonvolatile memory. The cards are held in "slots" within

the IntelliProx's internal memory. A Form-C relay output provides normally open and normally closed contacts for

door lock control. A door sense input provides door status for local annunciation if the door is held open. Programming

is accomplished using either D-Lite card database management software or the Keri Hand-Held Programmer (P/N:

HPP-22). With both the D-Lite program and the Hand-Held Programmer, access to the IntelliProx is controlled with

Personal Identification Numbers (PINs). A user must enter the PIN associated with the IntelliProx, and the PIN

associated with the host computer (when using D-Lite), before access to the IntelliProx unit is granted.

D-Lite is a simple, spreadsheet based IntelliProx slot/card management program that can enroll cards, upload a set of

cards to an IntelliProx unit, or download a set of cards from an IntelliProx unit. Refer to the D-Lite Users Manual for

programming instructions, P/N 01869-001. D-Lite can be used when the IntelliProx is used as a stand-alone entry

system; it is not compatible with the IntelliProx when the IntelliProx is used as a 26-bit Wiegand output reader.

Communication between a host computer (with the D-Lite program) and the IntelliProx unit is done through an RS-232

serial connection.

The Hand-Held Programmer works like a television remote-control unit, issuing commands to the IntelliProx with

simple two or three step push-button functions. Refer to the HPP-22 Quick Start Guide for programming instructions,

P/N 01831-003.

1 2 3 4 5 6 7 8 9 10